-->
We
often discuss about diseases on green tissues such as downy mildew. Do some of
disease pathogen capable of infecting woody tissues? Yes, they do. Some of the examples are:
Botryosphaeria canker (as shown on the picture above), Petri disease
(aka Esca, leaf symptoms pictured below), Crown Gall, and Eutypa dieback. In addition, some of the other
pathogens such as Phomopsis are also capable of infecting woody tissues. These diseases typically cause damages to the
infected vines in a long timespan. Thus, the infection today may not cause any
obvious damage until a few years from now. Moreover, these pathogens act more
like a “silent killer” and can shorten the life of the vine by 5-10 years.
Thus, the prevention of these diseases will benefit you in a long run. On the
other hand, if you have younger vines (up to 5 years or so), these diseases can
progress rapidly and cause a decline of the infected vine within a year or two.
Since these pathogens limit the movement of water and nutrients by infecting
xylem and phloem, typical symptoms of these diseases are discoloration of
leaves and shoots.
So,
how these pathogens infect grape vines? Since grape has a thick bark, there
will be very low probability of these pathogens infecting healthy bark tissues,
invade through cortex, phloem, cambium, and xylem tissues. Instead, they are more likely to start an infection
from exposed woody tissue, such as injury on trunk, or as you guessed, pruning wounds.
The
common questions I have been asked are about chemical management
strategies. Pruning wound treatment has
been discussed in different places and with different contexts. In California where Eutypa dieback is a big issue, they tested a wound paste with boron. They used Biopaste, which was not a product
in the US, but now we have a product called B-Lock (Nutrient Technologies, CA).
These pastes protect wounds from the infection by Eutypa and Esca. In
Australia and New Zealand, they have tested a product called Garrison, which
seems to work as well. However, Eutypa is relatively a minor problem in VA.
The survey of wood canker diseases by Dr. Phillipe Rolshausen (one of the authors of the article above) in 2008 could not
find a positive Eutypa case from VA samples.
In
addition to the paste, there are two fungicide treatments that have been
registered. One is Topsin-M which has a special local use label for VA, and the other is Rally, which has a supplemental label for pruning wound application. These will be applied as a paint-on or as
a spray. Please see the labels for
detailed rate and application information. One of potential advantages of
Topsin-M is that it works well against Botryosphaeria that is very
common in VA. If you decided to use these materials, you need to obtain
the labels. Please click the links above where you can find the label for special
local use for Topsin-M and supplemental label for Rally. You need to have these labels prior to the
application. Please
note that Topsin-M has a 2-day REI.
(Note: I am interested in setting up
demonstration plots for these paste and fungicide treatments, so, please contact me if you are interested in
participating in it.)
The
other regular wound paints, such as latex paints, are also used commonly (which
does not require a registration), but the general consensus among growers (not
only grape but also other crops) are that the paints are not very effective.
Another alternative method that has been discussed is a fungicide application
as you would during the regular season, but we do not have any materials
registered for such use. Moreover, it seems that the efficacy of the spray is
not consistent and does not last very long.
Therefore, my recommendation is that we need to go back to the basic, the use of the cultural practice. The fungi and bacteria that cause diseases on grape require a certain temperature range and more importantly, a wet surface. Thus, if the pruning wound is dry, there will be fewer chances for the pathogens to infect the tissue. The rain will also initiate the pathogens to release spores, so, it is very important to avoid rain. Please check the weather forecast before pruning and make sure you will get sunny days to ensure the wounds will be dried out in a few hours, and there will be enough time for wound to heal. You may also want to avoid pruning during the late afternoon because once the night falls, temperature drops and relative humidity increases, then wounds will not dry out for an entire night until the sun comes up.
Therefore, my recommendation is that we need to go back to the basic, the use of the cultural practice. The fungi and bacteria that cause diseases on grape require a certain temperature range and more importantly, a wet surface. Thus, if the pruning wound is dry, there will be fewer chances for the pathogens to infect the tissue. The rain will also initiate the pathogens to release spores, so, it is very important to avoid rain. Please check the weather forecast before pruning and make sure you will get sunny days to ensure the wounds will be dried out in a few hours, and there will be enough time for wound to heal. You may also want to avoid pruning during the late afternoon because once the night falls, temperature drops and relative humidity increases, then wounds will not dry out for an entire night until the sun comes up.
It
depends on other factors such as labor and your time, but if you can afford,
you may want to pay attention to the timing of pruning. In CA, they recommend growers to wait as late
as possible because under cool weather, pruning wounds take more time to heal.
It may take up to two weeks under low temperature range (40’s), and about one
week in mild temperature (50’s). The
same principals probably apply to us. We
have much colder winter than CA, and I would not expect pathogens to be active
in snow. However, it will take longer
for wounds to heal.
The
other consideration is to practice double pruning, which is also listed in the article above. The idea is to do pruning in two passes where
the first pass in winter or early spring to conduct rough pruning and then the
second pass in late spring to do final pruning. It has several advantages. First, you do not need to spend long time
under very cold winter weather to perfect your pruning. Second, it takes less
time when you do final pruning because you do not have to move long shoots from
the wires in the second run. Plus, third, even if the first pruning wounds take
time to heal and infected, the second pruning will get rid of infected tissues.
Make sure your pruning equipment is clean. Your old trunk may be infected with the pathogens, and they may have already produced spores that can be transferred from one vine to another. I understand that it will be very time consuming, but what you can do is make a 10% Clorox solution (10:90 Clorox:water solution) in a bucket, and dip your equipment between vines for 1-2 minutes. Or get 70% alcohol (rubbing alcohol) and spray onto the pruner. It is probably not practical to do it all the time, but you can do it after pruning heavily infected vines and/or after each row or section.
Make sure your pruning equipment is clean. Your old trunk may be infected with the pathogens, and they may have already produced spores that can be transferred from one vine to another. I understand that it will be very time consuming, but what you can do is make a 10% Clorox solution (10:90 Clorox:water solution) in a bucket, and dip your equipment between vines for 1-2 minutes. Or get 70% alcohol (rubbing alcohol) and spray onto the pruner. It is probably not practical to do it all the time, but you can do it after pruning heavily infected vines and/or after each row or section.
We
also recommend keeping vineyard clean of debris. Many wood canker pathogens can survive on
dead tissues, especially Bot. canker.
Thus, it is ideal to remove pruned woods out from your vineyard to be
composted (FYI, it will take a long time to compost woody tissue), or to be
burned. The other option is to bring
pruned woods to the row-middles and run them over with a bushhog or mower.
Hopefully, it will speed up the rate of decomposition. If you make a big cut, say from re-training
of a cordon, it would be the best to remove the old cordon out from your
vineyard. There will be no benefit from
keeping the old dead tissues in your vineyard.
Pruning surface shape and orientation are also important, especially when you make a big cut. If you make it flat and level, it can hold water. Thus, it is recommended to make a slant surface so that if there is rain, water will not stay on the surface.
Pruning surface shape and orientation are also important, especially when you make a big cut. If you make it flat and level, it can hold water. Thus, it is recommended to make a slant surface so that if there is rain, water will not stay on the surface.
Last,
but not least, I would like to mention about Phomopsis cane and leaf spot. The pathogen of this disease infects canes in
previous years, and produces spores on it during following growing
seasons. Thus, if you have infected
canes nearby new shoots, it will make it easier for the pathogen to infect it,
especially when the new shoot is coming beneath the old infected cane because
spores drips down from the old wound with rain.
So, please pay attention to the relative orientation and distance
between old and new shoots. Also, it gives you another reason not to keep dead
old shoots on your vines. Many people have asked me about a dormant application
of fungicide against Phomopsis. It
works, but it costs a lot, is harsh on equipment, and its efficacy is not that
great. Therefore, unless if you had a recent outbreak of Phomopsis, the best
management approach is to tighten in-season mancozeb application schedule to
protect new shoots when shoots are about 1-inch long.
So in summary:
-->
So in summary:
1.
The first line of
defense is cultural practice
a.
Keep pruning
wounds dry
b.
Double pruning
c.
Wait for warm
weather for the final pruning
d.
Keep vineyard
floor clean
e.
Consider pruning
surface angle and orientation (esp. for a big cut)
f.
Sanitize pruning
equipment, if possible
2.
Chemical
management is also available
a.
Topsin-M or Rally
for Bot canker and Esca (special labels are required)
b.
B-Lock paste
which contains boron (known to work against Eutypa and Esca)
i. These options can come in handy especially when you
make a big cut
c.
“Dreft” with 30%
aqueous suspension (wt/vol) showed efficacy against Eutypa; however, we do not
have a data on common trunkd diseases in VA such as Botryosphaeria canker
Comments
Post a Comment
Please leave your comment here. In order to avoid spam messages, l moderate comments, thus it may take a few hours for your comment to be posted on the page.